Mustang Tech

If yours is cast iron and the radiator hose inlet is on the RHS of the car then one of these will do. https://www.ebay.com.au/itm/32430525805 ... SwPzZfEkDT

Original 65's used an alloy pump. on a different timing cover. Welcome to drop in and let me confirm what you have.

Nice Work.

Nice Welds!!

Dwayne, What are those doovers?

Cool!! So you'll have the floor done in 15 minutes just like on the TV!!

There's plenty of armchair experts here and like Hybrid, I think 10mm should be sufficient if you're using urethane mounts. One thing to consider though, is whether you can easily remove and replace the gearbox without scratching up the tunnel.

Kerry!! Holdons???? Really??? They better belong to Bosskraft

Is it the block that's drilled incorrectly or is it the oil pan? Nice build by the way. Thoroughly entertaining.

You're almost done!!
Nice work!!

Nice work!

There should be enough room to mount the pump under the rear splash tray. I did a trial fit on a 67 and appeared to fit ok. Only issue would be checking levels. It looks as though it would fit a 65-6 also. Was going to do this but then i'd have to fill all the holes in the apron then repaint it. I a...

Shit! RIP Jacko.

Mr Ed, I did tell you that I would do it for you but No, you had to go out and do it yourself! You should have switched the Pos like I said.

Did you make 40 sets of those Brackets Mr Ed?

Those heads are awesome. They make huge power.

Nice work. Good to see another major build..