My engine bay is finally all stripped back to bare metal.
Before I spray the etch primer, there are some spots on the towers with light surface rust that I need to clean up. I've previously just used vinegar & water.
What is the best method to use to remove any surface rust from the bare metal?
Prepping bare metal for etching
Moderator: Moderators
Re: Prepping bare metal for etching
You could use the POR-15 metal ready product.
I'm sure there are other ways as well.
I'm sure there are other ways as well.
Re: Prepping bare metal for etching
Metal ready is good stuff
Re: Prepping bare metal for etching
Lovely, and I already have some here ![Smile :)](./images/smilies/icon_smile.gif)
![Smile :)](./images/smilies/icon_smile.gif)