I found this the other week browsing around, and it looked pretty good so I bought it. About 70 bucks shipped here. I thought I'd just put it up here if anyone is looking for a simple solution in the future, as most of the ones I've found are not only expensive but have the sender/relays as part of the kit, which I didn't want. I just wanted a controller. I didn't want to pay stupid money for some relays, a bit of wiring and a sender that only has a set on/off temp.
What I like about it is it works off any resistance based sender. You wire it up to any resistive based temp sensor, and then you can adjust the fan on temp with the box. It also had adjustable hysteresis, which means you can adjust the off temps also based on the resistance of that sender.
It has two inputs and outputs, so you can have two different on and off temps, and control either dual fans independently or dual fans with dual speeds. You can also used one of the inputs to trigger a warning light/buzzer if you wish and use the other for the fan(s).
It has built in 30amp relays, however I am just going to use these to trigger the relays I already have setup, as they are much easier to replace. In my opinion I would use a normal 40amp or so relay for the fans and have this trigger it. If you have dual fans you can easily setup dual speeds with this controller and a few relays. I have a good schematic for that if anyone wants.
It can also be put in run on mode so your fans runs while the car is off until it gets to the off temp.
Here are some pics as I just received it today. It's very small and seems well assembled. I will install it in a few days and get some more info for you all.
I mean you can really use it for anything that has a resistive based output.
![Image](http://i.imgsafe.org/013f04d42c.jpg)
![Image](http://i.imgsafe.org/013ee8d5a3.jpg)
![Image](https://i.imgsafe.org/017dc0e325.png)
here's a link to their site, instructions are their if you are interested
https://www.spiyda.com/magento/index.ph ... oller.html