lower quarter patch is in and not too bad - it will need a skim of filler. Wheel arch replacement is in - same got a reasonable low patch at the rear that should knock out with a bit more work.
Happy for critical appraisal - this is my first attempt at exterior metal repair - if its shit just say so - there is a fair amount of work to got to get to rebuild the lower front of the rear quarter - after this side is done I’m not sure whether I wont bite the bullet and replace the whole rear quarter on the driver side. If this side is shit - well its a bit of time with a grinder and away you go as they say. This is a learning project for me - but I want the end result to be as near perfect as possible.
Top of the wheel arch is a flange whilst sides are butt weld.
Anyone contemplating using the wheel arch replacement sections - they are not great - there is no fold to match the body line in front of the wheel arch nor does it follow the curve below that body line. Quite a bit of work to get it to follow the body line but of all the areas on this patch - its the bit I am happiest with for fit and line!
![Image](https://i.postimg.cc/VNrS0Y6M/4-AB4-DE42-6-C8-B-4732-B4-D6-ED1-D443-F6-E3-B.jpg)
This is where it came from....some bonds artistry....Mofo’s
![Image](https://i.postimg.cc/DwYJzW2n/92-B40811-670-A-4898-88-C1-C22811-F721-F7.jpg)